![]() ![]() It consists of a cheap Bluepill module, simple PCB and a few resistors only. I have better results with lower flow rates (dia 0.4 or 1900%), but more testing needs to be done. I would like to present a very simple modification of the Cetus 3D printer (MK2) to Klipper firmware. Filament diameters of around 0.38 translate to the 2200% cmeyer posted (flow rate factors in quadratic, so use fine steps when adjusting it). ![]() Flow rate percentage adjustments mess up the ‘layer view’ in Cura (from years of experience with an Ultimaker 2, I find this one of the most helpful features in Cura). Keep in mind that you may have to find a physical solution for levelling the build bed when using Cura.ĭ) With the current version of Cura (v3.3.1) it is better to adjust the flow rate of molten filament via the filament diameter, than the flow rate percentage. The nozzle is too far away from the bed, if the individual lines can be easily separated and do not stick together.)Ĭ) Up Studio allows for an 9-point calibration routine for the z-axis. The nozzle is too close to the bed, if the brim thickness (z-direction) gets to thin and translucent. If you use a brim around a test-model in Cura, the correct height is achieved, if the individual lines that make up the brim squash together nicely. With Cetus2 each color can be mixed at any ratio you choose, sparking your creativity and turning your ideas into a colorful reality. (I think a painfully precise calibration is overkill. 509.00 599.00 Add to cart Color Never Been Easier Single-color production limits makers who desire creative color patterns or real-life details. I did compile my ‘own version’ from the start code by chrisevich. Perhaps the info below will help someone in the future:Ī) I used the start and end code from chrisevich ( #11) which worked nicely for me.ī) the z-axis calibration code posted by cmeyer never worked for me. I just wanted to thank everyone who contributed to this thread - it helped me tremendously when setting up my Cetus3D MkII with Cura. G1 X50 E360 F300 extrude a 5cm purge line G1 X2 Y178 F5000 move to back right corner Have you tried working on the offset settings In calibration you made sure the plate was even, level and the nozzle height was consistent on every zone of it, but this process says nothing specific about the distance of the nozzle from the bed, usually the thickness of a sheet of paper is accurate and within tolerance so you dont need further steps. Be careful to have the orientation correct. M206 X-180 offset X axis so the coordinates are 0.180, normally they are -180.0 Disconnect printer, open the case, carefully remove existing CPU and put the tinyFab CPU in place. ![]() Do the paper test and use a gcode file something like this:p.p1 the nozzle offset may be different than in Cetus Studio. make sure your nozzle offset is correct in the starting g-code ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |